POWER FLUSHING ACCESSORIES

RANGE:

QUICK LINKS

NEED HELP?

For advice on the correct product for any application, contact our telephone help line on 01727 875020.

CP2 circulator pump head adaptor

FOR USE WITH KAMCO POWER FLUSHING PUMPS

The CP2™ adaptor has been developed for use with heating system power flushing pumps, to enable them to be connected directly onto the body of standard heating system circulator pumps, after removal of the motor head.

The compact dimensions of the CP2™ allow for easy connection of a power flushing pump, even in boilers which contain the circulator pump within the casing, such as combination and system boilers, where access is often difficult, or which have non-standard connections.

When using the CP2™ there is no need to physically disconnect the circulator pump 1½” unions, which are often seized and difficult to remove.

During power flushing, the circulator pump body (volute), which may often contain considerable corrosion debris, is included in the cleaning process.

All combi system radiators may be power flushed, as there is no need to remove one to connect onto the radiator tails.

The central heating (primary) water side of the secondary heat exchanger of combination boilers can be efficiently flushed with the heat exchanger in place in the boiler casing, giving useful time savings.

CP2™ has been designed primarily for the Grundfos Selectric and combination boiler pumps, but will fit a number of other units, including some Myson, Terrier, Circulator Pumps Ltd and Wilo Gold models.

CP2 circulator pump adaptor
  • INSTRUCTIONS
  • WHAT'S IN THE KIT?
  • ENGINEER'S TIPS

Click below to download the full data sheet/instructions (PDF)

Click here to download the full data sheet/instructions

CP2 kit includes:

  • Adaptor body
  • 2 x 50cm adaptor hoses
  • 4 x M5 socket head bolts
  • 2 x M6 socket head bolts
  • Hexagon key to adjust centre connector
  • Large 'O' ring to seal body to pump
  • Small 'O' ring to seal chambers of pump
  • Plastic carry container
  • Engineer's tips:

    On certain pumps it can be difficult to get a seal on the large outer 'O' ring.

    In such cases the addition of a standard Grundfos flat 'O' ring attached to the CP2 body can enable a seal to be made. The flat 'O' rings can easily be removed from any new or used Grundfos pump head.