Search the Kamco website by entering keywords here:

CLICK ABOVE TO CONTACT US

QUICK LINKS

POWER FLUSHING TRAINING

FIND A LOCAL STOCKIST

KAMCO NEWSLETTER

FIND A LOCAL POWER FLUSHING ENGINEER

LIST OF BOILERS WITH ALUMINIUM HEAT EXCHANGERS


MATERIAL SAFETY DATA SHEETS

This site contains a number of instruction sheets in PDF or WORD format. You can download
Adobe® Acrobat® Reader® by clicking below

and download a WORD viewer by clicking here

SYSTEMSAFE-DM: scale & corrosion inhibitor for all systems

PREVENTS SCALE & SLUDGE FORMATION

PREVENTS INTERNAL PITTING & GALVANIC CORROSION

PREVENTS HYDROGEN GAS FORMATION

PREVENTS MICROBIOLOGICAL CONTAMINATION

Once a heating system has been power flushed to remove sludge and corrosion deposits, it is important to protect it from further deterioration.

This can be achieved by treating the system water with SYSTEMSAFE-DM, a balanced blend of corrosion and scale inhibitors, formulated to provide complete protection against system corrosion and scale formation. It gives long term protection to central heating systems, preventing internal corrosion, scale deposition and boiler noises. It extends the life of systems and maintains operational efficiency.

At the end of the power flush, and before disconnecting the CLEARFLOW® pump, SYSTEMSAFE-DM should be added to the CLEARFLOW® tank and circulated through the system for a further three minutes before disconnection. Use one litre per 100 litres system water content, or 1% dosage rate by volume.

Application & usage:

To ensure that all SYSTEMSAFE-DM enters system, add to the feed and expansion tank after isolating water supply and draining off 15 litres (3 gallons) of water. Allow system to re-fill.

Alternatively, SYSTEMSAFE-DM may be introduced directly into a radiator, using a SYSTEMSURE injector unit.

New Systems: Before adding SYSTEMSAFE-DM to a new system, we recommend a pre-commission cleanse with SYSTEM PRE-CLEAN to remove installation and manufacturing debris such as swarf, grease and jointing paste, to mobilise and remove any dust and dirt, and neutralise any acidic flux residues.

Existing Systems: It should be noted that no corrosion inhibitor can reverse previous corrosion damage, and to optimise the system efficiency, and allow SYSTEMSAFE-DM to work to best effect, we advise that the system should first be flushed with POWER FLUSH FX2 or HYPER-FLUSH. This is particularly important in cases where a new boiler or heat exchanger is being added to an older installation.

Correct dosage: The exact dosage rate is not critical, as SYSTEMSAFE-DM will work effectively within a +/- 20% range, but a Systemsafe-DM test kit is available to check for optimum treatment level. The test kit determines the level of molybdate, which will be 330 ppm at the standard dosage rate. The kit contains reagents for approximately thirty tests, together with sampling syringe and test tube with colour chart and instructions.

SYSTEMSAFE-DM

*** AUGUST 2006 ***
SYSTEMSAFE-DM IS NOW APPROVED TO THE BUILDCERT / DWTA PERFORMANCE STANDARD
Click here to visit the DWTA websiteSystemsafe-Dm is approved to the DWTA Performance Standard

Packaging:

• Carton of 12 x 1 litres

• Carton of 4 x 5 litres

• 25 litre drums

CLICK HERE TO DOWNLOAD MATERIAL SAFETY DATA SHEETS
Corrosion Inhibitor Tests

We have carried out a series of tests on the effectiveness of SYSTEMSAFE-DM against other brands of inhibitor.

Click the picture above to see the results after just 14 days.

 

Kamco Limited is ISO9001 registered
 
Click here to see our Privacy Policy How to find us