• Generates
high profits and creates satisfied customers with fewer
call-backs
• Acid
resistant pump for descaling combi boilers and water
heaters
• High
flow rate and instantaneous flow reversing action for
rapid sludge removal
• Power
flush systems with up to 25 radiators / three storeys
• Average
job completed within 4-5 hours
• Easy
to carry - pump weighs only 12kg
The CLEARFLOW® CF30
DDV is a purpose built power flushing and
descaling pump with
instantaneous flow reversing device, for power flushing
complete systems up to 25 radiators. Complete with
all the hoses and adapters that you're likely to
need, a starter pack of chemicals, a comprehensive
manual and FREE
TRAINING.
This
upgraded
version of the original CF30 incorporates two dump valves,
so that fresh water can be forced at high velocity in
either direction during the dumping process, purging
contaminated water through the dump hoses to waste.
By
this means, all parts of the system can be scoured
by high velocity turbulent water, improving the efficiency
of power flushing and reducing the job time. One single
man can power flush a heating system in less than four
hours, solving circulation and noise problems resulting
from corrosion and sludge deposits.
The
powerful flow, combined with an instantaneous flow
reversing device, will dislodge and mobilise deposits and
corrosion which resist traditional system cleaning methods.
Radiators may be individually flushed in sequence, and
the progress of the the power flushing process can be clearly
seen at all times through the translucent tank.
With
POWER FLUSH FX2 flushing and descaling liquid, the
CLEARFLOW® DDV
will completely flush and clean a system in just one
service visit, with no need for an initial visit to
pre-treat the system.
NOTE: The CLEARFLOW® CF30 pump
is designed to allow hard flushing of a heating system with
minimal dismantling. Generally, it is only necessary to remove
either the
system circulator pump, or alternatively one radiator for
attachment of the CF30 to the heating system, although there
are other possible attachment methods - see Detailed
Instructions (Section B) for details. Radiators
may be individually flushed without removing or disconnecting
them from the system.
The
unit may be used with any commercially available chemicals
currently in use for flushing and descaling heating systems,
including strong acids or alkalis. Pumps with 220 volt motors
are single phase, and may be used on a standard domestic
13 amp supply.
A
5 ampere fuse should be fitted in the plug top. We recommend
the use of a residual current circuit breaker plug or adapter
for extra protection.
CONTACT
KAMCO FOR CF30 DDV PRICE OR TO UPGRADE YOUR
SINGLE-DUMP PUMP TO DDV |