COMBIHEAT features:

• Provides heat to tackle problem systems.

• Increases power flushing efficiency.

• Reduces power flushing time.

• Helps clear severely choked radiators.

• Cost effective.

• Simple to use.

The CombiHeat is an optional heating element for use with the CombiMag Power Flushing Filter.

When undertaking the chemical flushing stage of a power flush it can be beneficial for the water to be warm, ideally around 50°C. This heat input generally enhances the performance of flushing chemicals, and reduces the time taken for a power flush.

If operational, the central heating boiler is usually the source of this heat, but if a non-functional boiler is being replaced, boiler heat may not be available. When installing a new boiler to an existing system, it is not advisable to leave the power flush until the new boiler is operational because of the very high risk of contamination of the new boiler with debris from the old system, and this would invalidate a boiler warranty.

In these cases, and in other situations when the boiler cannot be fired, the CombiHeat can be used to raise the water temperature higher than ambient.

The CombiMag screw cap with the magnetic element is removed from the cylinder and replaced with the CombiHeat power flush heater element.

By utilising a common cylinder the CombiHeat is an economical alternative heat source. It is particularly useful when applying heat specifically to one or two problem radiators when normal power flushing has failed to remove heavy, adhesive deposits. The corrosion resistant element enables the CombiHeat to be used with all power flushing chemicals in common use.

Location of the CombiHeat and CombiMag filter:

Connect the CombiMag inline between the heating system and prior to the Kamco power flushing pump, as described within the CombiMag instructions, so that the water flow enters the bottom of the cylinder and leaves at the top.Click the diagram (left) to see a larger version.

NOTE: The Pressure Relief Valve supplied with the CombiHeat must be fitted to the CombiMag cylinder before the heater is used.

For detailed instructions, click the link in the right hand column.