|
|
|
POWER FLUSHING CHEMICALS: product
range
|
|
click
the pictures for detailed information
POWER
FLUSH FX2 : 'one
shot' power flushing & descaling liquid |
|
Power
Flush FX2 is designed for
use with CLEARFLOW® power flushing pumps, and
is the flushing liquid to choose for the
most rapid and effective results. It is a vigorous
'one shot' flushing and descaling liquid which
starts to work immediately after addition to the
system. |
|
HYPER-FLUSH:
non-acid flushing liquid - suitable for all metals,
including aluminium |
|
HYPER-FLUSH is the non-acid
flushing liquid with extra solvency power
to take debris into suspension for easy removal
by power flushing. It penetrates, loosens and
dissolves rust, sludge, corrosion and light scale
deposits during normal operation of the system,
without formation of particulate matter to cause
blockages and damage pumps. |
|
NEUTRALISING
CRYSTALS : for
neutralising acid chemicals before disposal
|
|
Neutralising
Crystals are added to the CLEARFLOW® tank after
the final power flush 'dump' (when water leaving
the dump hose is crystal clear), and circulated
briefly to ensure neutralisation of any residues
after use of acid descaling products. |
|
SYSTEMSAFE-DM: scale & corrosion
inhibitor |
|
Once
a heating system has been power flushed to remove
sludge and corrosion deposits, it is important to
protect it from further deterioration.
This
can be achieved by treating the system water with
SYSTEMSAFE-DM, a balanced blend of corrosion and
scale inhibitors, formulated to provide complete
protection against system corrosion and scale formation.
|
SYSTEM
PRE-CLEAN: pre-commission
cleanser for new systems |
|
New
and modified heating systems invariably contain installation
debris and foulants such as residues of solder fluxes,
jointing compounds, copper swarf, oil and grease,
and even casting sand from within boiler heat exchangers.
In
order to prevent future pin-holing of radiators,
and corrosion problems, it is important to thoroughly
flush new heating systems with SYSTEM PRE-CLEAN.
|
SYSTEM-HUSH:
cure for boiler noise / kettling |
|
Some
heating systems can be susceptible to noise problems
as a result of baked on corrosion and limescale deposits
on boiler heat exchangers.
Whilst
power flushing may cure this, on some systems it
may be an ongoing problem. Addition of one litre
of SYSTEM-HUSH, together with
the SYSTEMSAFE-DM, is recommended to cleanse the
heat exchanger during normal system operation. SYSTEM-HUSH
may be left in the system without draining.
|
pH
paper: 5 metre roll |
|
Checks
the strength of chemicals after neutralisation |
|
|
|
|
